Traditional Shower Outlets

Caroflow Shower Outlets are suitable for installation in vinyl sheet flooring or tiled floor finishes and provide an extremely aesthetic solution to the problem of trapped drainage from high performance shower units (or communal shower areas) with a limited floor void in which to install and drain from.

Both Body Sets and Clamp/Trap Sets, are manufactured in electrostatically coated, pre-treated, LM6 Aluminium (Corrosion Resistant) Silicon alloy to, with stainless steel fixings.

Available with either a vertical or horizontal take-off, the depth of the whole body unit is only 155mm, small enough to be installed within the space formed by 150mm joists when supported on a suspended timber floor and yet still be able to give a full depth of trap and drain at a constant rate of over 0.75 litres per second.

Connections

Both the vertical and horizontal units will allow direct connection to 40mm (1.5”) solvent weld pipe or to push-fit using proprietary pipe manufacturer’s fittings.

Performance

Caroflow shower outlets have been tested and achieve a constant flow rate in excess of 0.75 litres per second, connected to a 40mm (1.5”) pipe.